Making Vintage Cane Back Chairs
Vintage cane back chairs – If you have a chair with a broken seat, you may find great satisfaction in placing a new seat in it and the useable chair again. There are several types of rod and methods of spanking. Learn how to turn a chair seat with holes along each edge.
Make vintage cane back chairs, Examine the old cane tissue still on the chair, if any. It may be helpful to have a whipping chart. Use a knife, ice pick and scissors to remove the old seat. Clean remaining debris. Coil a few rod and clip wires with a clamp for clothing. Place in warm water for 15 minutes. It will become flexible. Place a plug in the center hole in the front and rear rails. If each lane has a number of holes, start with 1 to the center right.
Pick a cane and run your fingers through it. It will run smoothly in only one direction. That is the direction you want in the vintage cane back chairs. Insert 4 inches of the back of the rod into the hole in the center of the back and replace the plug. The other end of the feed through the central hole in the front. Pull firmly and replace the plug. Feed the cane through the next hole to the right in the front of the chair.